KESS V2 FW V4.036 add tokens - SUCCESS (personal experience)

I bought a  KESS V2 Master Truck with K-Suite version 2.22 Firmware 4.036  online three months ago. When the tokens used up, I followed the guide video to add token and it was working. Here I will give a clear explanation of KESS token reset.

Before adding token you need download two zip files:

1. KSuite-tokens.zip
2. zip

After that you can start toad tokens for  KESS V2 truck , I summarized following steps for your reference:

Step1. First you should check if the KESS V2 K-suite software is well installed.

Open My Computer >> Device Manager >> Universal Serial Bus Controller >> USB Device

Step2. Remember disconnect both local area network and wireless network otherwise you will damage the device.

Step3. Unzip Tool.zip file you will get 3 files: "K10033818" ECU-Tuners, "Tokens" folder and "Token1.tok", copy these 3 files to the desktop, then delete "Tool folder" and the zip file both on the desktop.

Step4. Cut KSuite-tokens.zip to local disk [C] and unzip it.

Step5. Open "K10033818" ECU-Tuners browse My Computer >> Local disk [C] >> KSuite-tokens >> KSuite. Click "OK" >> "Reset Token Count" >> "OK".

Step6. Wait for a minute, it will show KSuite is updating, after that close the KSuite interface.

Step7. Delete the "KSuite-tokens" folder in local disk [C], unzip KSuite-tokens.zip and get "KSuite-tokens" folder again.

Step8. Rename "Token1.tok" on desktop to "Token2.tok", copy "Token2.tok" to "Tokens" folder on desktop.

Step9. This step is to repeat Step5 and Step6, after that you can add tokens for KESS V2 successfully.

Also here I want to thank engineers of  Www.diyobd2.fr  they gave me much useful help to add token for my KESS V2.

This is from  OBD2 Francais  technical support website: KESS V2 FW V4.036 add tokens - SUCCESS (personal experience)

This is the  video guide for KESS V2 reset token :