Have got the alliance vi to work with Consult3 plus software. And make Consult III+ to run it with Ford VCM II interface.
CarDaq
Actica Passthru+ XS
Python1B
Nissan USB Diag
Alliance VI
And The obvious tool VI2
all these are the best to work with Consult 3 plus.
others will also work but maybe not as well.
The Ignition ON its not seen if you use VCM II
I use AVDI and Ignition ON it is not seen too
I read that no matter what j2534 tool you use the Ignition ON its not seen
Probably, only if use Alliance VI2, but alliance vi is quite a bit more complicated to set up
Here is thesetup of VCM II with Nissan Consult 3+.
For ford VCMII
In the Diagnostictool.ini put Ford-VCM-II
Install the consult 3 plus
Install your VCMII Manager and drivers.
In passthru 4.04 in reg edit and rename NISSAN_VI2 To something else
change name Bosch Ford-VCM-II to NISSAN_VI2
Reboot computer and test it
I tested it once with limited success.
Attachment: [Diagnostictool.ini]
Note 1: [alliance vi]
The sonde alliance vi is the end for the sonde can clip RTL. remplaced by sonde alliance vi but what is it.
Renault Aliance VCI = 100% Same with Nissan Consult III VCI...
Just & ONLY different name...
Note 2: [workable sw]Clone Consult III (who using patch) for to working with Nissan Consult III S/W, DID NOT working with Clip Software!!!
It seems now Clip S/W needs NEW "Pill" for Clones..