How to run ISTA-P with K+DCAN cable using ICOM A2

This is the instruction on how to run Rheingold ista / p with  K + Dcan USB cable  using  BMW ICOM A2  diagnostic tool.

 

1.Disable firewall.

2.Remove voltage constant.

3.Extract and copy the ICOM emulator xml files to:

*: \ Apps \ wsm \ apps \ agent \ data \

4. In VMware network editor, ensure "VMnet0" is set to "bridged" and your LAN network adaptor is selected in the drop down menu.

5. In VMware network editor, add a new network called "VMnet3" and set it up as shown in the picture below:

Note: Click "apply" and "ok" and close down VMware.

6. Open VMware again and start emulator using the k + dcan snapshot. Once it has loaded up, go to the vm settings and change network adaptor 1 to "VMnet3 (host only)". Click "ok" then wait 30 seconds for network to re-initialise.

note: you can now create new snapshot if you want.

7. Connect  K + Dcan cable  to emulator and car and run "Ifhsrv32" using icon on desktop emulator.

note: ensure k + dcan cable usb icon is active in the vm.

8. Start ISTAP native, start a session and choose "ICOM emulator" in connection manager screen.

note: if everything is ok, the led on your cable should start to flash after a minute or so. If not, recheck emulator settings (ie com9, latency timer set to 1 etc.).

Ceci est du site Web du support technique  Www.diyobd2.fr : Comment faire avec câble pour Executer ISTA P K + Dcan Utilisant ICOM A2