KESS V2 FW V4.036 add tokens - SUCCESS (personal experience)

I bought a  KESS V2 Master Truck with K-Suite version 2.22 Firmware 4.036  online three months ago. When the tokens used up, I followed the guide video to add token and it was working. Here I will give a clear explanation of KESS token reset.

Before adding token you need download two zip files:

1. KSuite-tokens.zip
2. zip

After that you can start toad tokens for  KESS V2 truck , I summarized following steps for your reference:

Step1. First you should check if the KESS V2 K-suite software is well installed.

Open My Computer >> Device Manager >> Universal Serial Bus Controller >> USB Device

Step2. Remember disconnect both local area network and wireless network otherwise you will damage the device.

Step3. Unzip Tool.zip file you will get 3 files: "K10033818" ECU-Tuners, "Tokens" folder and "Token1.tok", copy these 3 files to the desktop, then delete "Tool folder" and the zip file both on the desktop.

Step4. Cut KSuite-tokens.zip to local disk [C] and unzip it.

Step5. Open "K10033818" ECU-Tuners browse My Computer >> Local disk [C] >> KSuite-tokens >> KSuite. Click "OK" >> "Reset Token Count" >> "OK".

Step6. Wait for a minute, it will show KSuite is updating, after that close the KSuite interface.

Step7. Delete the "KSuite-tokens" folder in local disk [C], unzip KSuite-tokens.zip and get "KSuite-tokens" folder again.

Step8. Rename "Token1.tok" on desktop to "Token2.tok", copy "Token2.tok" to "Tokens" folder on desktop.

Step9. This step is to repeat Step5 and Step6, after that you can add tokens for KESS V2 successfully.

Also here I want to thank engineers of  Www.diyobd2.fr  they gave me much useful help to add token for my KESS V2.

This is from  OBD2 Francais  technical support website: KESS V2 FW V4.036 add tokens - SUCCESS (personal experience)

This is the  video guide for KESS V2 reset token :

Carprog v8.21 100% read & write Opel CAN Siemens Simtec 71.6

Cool! Just Succeed in reading and writing Opel Siemens Simtec ECU 71.6 Advanced CAN v0.7 with  Carprog 08/21 ; i mean, i used this Carprog to change mileage. Share with you all.

My Carprog 8.21

The source (diyobd2.fr) is advised by a forum fellow. His has lots of experience on new update regarding mileage correction:

Focus 2008 .... ok

Cmax 2010 .... ok

opel many ecu (bensin and diesel) .... ok

Fiat croma, punto, bravo ... ok

Passat b6 2007 .... ok

This is what i did ...

Open Carprog v8.21 interface

Select ECU-> Opel CAN-> Siemens Simtec 71.6 Advanced v0.7

Make sure that Carprog and ECU is connected in a good condition

Then select Read EEPROM

Click OK

Connecting to ECU ...

Reading EEPROM ...

Reading 100%, Eeprom info

Change the mileage, then click Write EEPROM, OK to continue

Connecting to ECU ...

Writing EEPROM ...

Writing 100%

Yes. Change km success with  Carprog eight twenty-one online

What functions can Lexia 3 V48 program for Citroen C4 and C5?

Here is a list including Citroen C4 and C5 functions that can be programmed via Lexia 3 V48 diagnostic tool so you can see what it might be possible to add / is missing from your car. This list is applicable to C4 and C5 because they share the same computer. The reliable Leixa 3 scanner is available in this shop: http://www.diyobd2.fr/wholesale/lexia-3-pp2000-citroen-peugeot-diagnostic-interface.html

Customer Options

On-the-move locking option

Detection of driver’s seat belt not fastened

Presence of front foglamps

Multiplexed electric rear view mirrors with foldback

Presence of rear screen wipe in reverse gear

Automatic relocking

Type of alarm

Presence of a trailer relay unit (BSR)

Type of deflation detection

Type of daytime-running lamps

Menu: vehicle definition – equipment – driver’s information

Overspeed alert option

Passenger’s seat position memorisation control unit option

Automatic gearbox option

Right-hand-drive vehicle

ESP option

Driving school vehiclde option

3-door vehicle

Engine oil temperature sensor option

Coolant level sensor option

Passenger airbag option

Presence of the telematic unit (RT3)

Presence of water-in-diesel-fuel sensor

Presence of the air pump

Multiplexed ABS option

Estate vehicle

Presence of a piloted manual gearbox

Origin of the water-in-diesel-fuel information

Driving position memorisation option

Presence and type of vehicle cruise control

Origin of the oil temperature information

Presence of the parking assistance button

Type of parking assistance

Presence of the log of functions

Presence of the log of alerts

Parking assistance with visual information

Parking assistance with sound information

Presence of a fixed centred controls (FCC) steering wheel

Presence of a programmable button

Type of detection of presence of fuel cap

Piloting of the diesel fuel additive pump

Type of alternator

Engine ECU compatible with the vehicle speed limiter

Presence of button for measurement of available space

Presence of warning lamp for measurement of available space

Type of seat belt fastening management contol unit

Total time before next service (threshold)

Threshold for first service

Maintenance threshold (marketing)

Kilometre threshold for forcing of customer mode

Memorisation of faults

Kilometre threshold for automatic change from park mode to customer mode

Type of personalisation menu

Presence of an electric secondary brake

Presence of a battery charge indicator

Control unit for memorisation of rear seat positions

Presence of the welcome function for the rear passengers

Electrically adjustable rear seats

Presence of the welcome function for the driver

Origin of the oil pressure information

Number of seat belt non-fastening switches

Sensor for detection of presence of a front passenger

Detection of non-fastening of the driver’s seatbelt

Detection of non-fastening of rear passengers’ seatbelts

Detection of non-fastening of the front passenger’s seat belt

Detection of non-fastening of the middle front passenger’s seat belt

Presence of a radio RD4

Presence of a red warning lamp for the Steering Assistance alert

Presence of an orange warning lamp for the Steering Assistance alert

Tolerance on value set for the cruise control / speed limiter

Lane Departure Warning System option

Format for exchanges of data with the switch module under the steering wheel

Presence of a fuel pump

Types of information managed by the seat belt fastening control unit

Retention of the brake when starting on an incline

Type of vehicle

Presence of a hands-free kit

Presence of a CD changer

Presence of a rear height corrector control unit

Detection of non-fastening of middle rear passenger’s seat belt

Detection of non-fastening of rear LH passenger’s seatbelt

Detection of non-fastening of rear RH passenger’s seatbelt

Presence of a steering angle sensor

Presence of a rev counter control unit or an odometer warning control unit

Presence of an audio equaliser amplifier

Detection of non-fastening of seat belts for the third row of seats

Sound alert for parking assistance emitted by the switch module under the steering wheel

Display of fuel consumption without overconsumption due to the regeneration of the particle filter

Time of response by the engine ECU to the BSI when operating the cruise control

Display of the alert for fastening of rear seat belts when opening a door or switching on the ignition

Retention of braking (by the ESP) for 2 seconds when starting on a gradient

Menu: air conditioning – cabin heating

Presence of an outside temperature sensor

Deactivation of load-shedding of the aircon blower

Presence of an aircon compressor with external control

Presence of a pollution sensor

Presence of an additional blower

Type of sunlight sensor

Type of air mixing

Type of air distribution

Type of additional heating

Aircon compressor drive ratio

Presence of piloted blower

Presence and type of blown air sensor

Type of air inlet

Position of the outside temperature sensor

Type of outside temperature sensor

Recovery of the heat from the exhaust gases for heating the passenger compartment

Recovery of the heat from the engine for heating the passenger compartment

Type of rear air blower

Type of climate

Type of aircon compressor

Presence of air conditioning

Menu: lighting - signalling – visibility – rear view mirrors

Sunlight sensor option

Rain sensor option

Rear screen wipe option

Headlamp wash option

Vehicle location option

Automatic lighting of the instrument panel and multifunction screen as a function of ambient brightness

Automatic lighting of hazard warning lamps in the event of impact

Timing of guide-me-home lighting option

Automatic lighting of hazard warning lamps under heavy deceleration

Dipped beam and main beam in the same lens

Presence of front foglamps

Daytime-running lamps

Multiplexed electric rear view mirrors with foldback

Rear view mirrors indexed to reverse gear

Presence of rear screen wipe in reverse gear

Lighting of hazard warning lamps when pressing the emergency call button

Presence of rear foglamps

Very cold option

Main beams and foglamps in the same lens

Black Panel mode option

Guide-me-home lighting option

Type of headlamps

Type of daytime-running lamps

Presence of a rain/sunlight sensor with regulated-speed screen wipe

Presence of directional headlamps that can be diagnosed

Presence of a lighting stalk with four positions

Presence of a stalk with one-touch activation of automatic wipe

Activation of automatic lighting of headlamps via the personalisation menu

Presence of a third button on the high frequency remote control for lighting of headlamps

Presence of a left hand reversing lamp

Presence of a right hand reversing lamp

Presence of parking lamps

Presence of rear left hand foglamp

Presence of rear right hand foglamp

Control of front foglamps via a dedicated output from the engine relay unit ( BSM)

Adjustment of the lighting rheostat in day mode

Type of interior lamp switch

Menu: locking – doors and tailgate - immobiliser - alarm

On-the-move locking option

Option for opening the boot via the high frequency remote control

Mercosur windows logic

Central closing by high frequency remote control

Type of locking

Two multiplexed front windows

Number / type of sun roof

Opening rear screen option

Child safety option

Option for closing of windows by high frequency remote control and by key

Type of child safety

Automatic relocking

Presence of central locking

Type of alarm

Type of anti-theft

Option for permanent locking of boot

Electric front windows with anti-pinch

Supplier of the high frequency remote control

Inviolability mode

Presence of a multiplexed sun roof

Alarm volumetric detection

Menu: fuel gauge low – oil level gauge low

Type of fuel

Oil level sensor option

Tank capacity

Resistance of gauge, tank empty.

Resistance of gauge, tank full

Fuel gauge law - alert level

Fuel gauge law - selection of the vehicle

Selection of engine oil gauging table

Origin of the oil level information

Condition for measuring the oil level

ECUs Also Fitted

Fixed centred controls (FCC) steering wheel

Airbag

Engine relay unit (BSM)

Rain / sunlight sensor

Driver’s door module

Passenger door module

BSI

Alarm

Parking assistance

Driving school module

Instrument panel

Radio

Lane Departure Warning System

NaviDrive telematic unit (RT3)

Display

Rev counter control unit

Trailer relay unit

Air conditioning

Driver’s seat memorisation control unit

CD changer

Hands-Free Kit

Diesel fuel additive module

Presence of steering angle sensor

Engine ECU

Automatic gearbox / piloted manual gearbox

ABS / ESP ECU

Deflation detection

Power steering

Directional headlamps

Multiplexed diesel fuel additive pump

Ceci est du support technique du site Web Lexia 3:What Citroen C4 and C5 functions can be enabled via Lexia 3?

[Feedback] Obdstar F108 success on Citroen aircross 2015

This is a review on  Obdstar key programmer F108  running on  Citroen Aircross 2015th .

This is OBDSTAR F108 package i got from diyobd2.fr. Sorry for photos are not with high definition as you wish.

The package includes:

F108 main unit

TF card

All items were packed in a hard paper box, in a good condition ... No damages.

I purchase this device because of the following reasons:

1) i have 2015 Citroen aircross needs adding new keys, and this is the only professional auto key programmer for Citroen (also, Peugeot and DS)

2) my wife drives 2009 Peugeot 508. F108 works for that also; maybe in the near future, it will ...

3) The price point for F108 was just right. € 157 is ok price for me.

4) F108 can read PIN codes and program keys together. I do not need to buy other new PIN code readers.

To begin with, I go through the basic functions. Below is the start-up screen as soon as the device is plugged into the OBDII port (The unit will power-up as soon as it's plugged in).

It gives options then:

FUNCTION

SETTING

ABOUT

SELFTEST

IMMMOBILIZER

Immo software v31.09

Peugeot

Citroen

DS

...

The device is easy to use (plug and play) and set-up is pretty self explanatory. i cycle through the scanner using the arrow buttons and enter / back buttons.

And managed to read Citroen aircross PIN code

All done with the help of the screen instruction - very detailed.

Sp, if you're a home mechanic, it's is seriously worth of your purchase, like me. Just need access to your car (Peugeot, Citroen, DS). It's straight forward and easy to operate, accessing cars and reading security codes and programming new keys quickly.

The instructions are clear to follow with pictures for every step. Updating the software is easy too, especially if using a laptop with an SD card reader as you plug the tool's card into your computer, run the software, update, unplug and go.

It's a happy shopping in China; but i think it would be better if  Obdstar F108  has the option of the French language.

This is from  OBD2 Francais  technical support website:[Feedback] Obdstar F108 success on Citroen aircross 2015